HP Hitachi Dynamic Link Manager Software - Manual (Page 209)

4. HDLM Operation
187
name = clear, completion time = yyyy/mm/dd hh:mm:ss
#
3. Check to see whether the statistical information for all the paths has been
initialized.
The following shows how to execute the command:
# /usr/DynamicLinkManager/bin/dlnkmgr view -path
4.2.7 Viewing and Setting Up the Operating Environment
This section explains how to display and set up the HDLM operating environment.
(1) Viewing the Operating Environment
To display the operating environment, execute the
dlnkmgr
command's
view
operation with the
-sys
and
-sfunc
parameters specified.
The following shows an example in which the command is executed:
# /usr/DynamicLinkManager/bin/dlnkmgr view -sys -sfunc
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster :
Elog Level : 3
Elog File Size(KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(60)
Intermittent Error Monitor : off
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
#
To display the operating environment of the audit log, execute the HDLM command's
view
operation with the
-sys
and
-audlog
parameters specified.
The following example shows how to execute the command:
# /usr/DynamicLinkManager/bin/dlnkmgr view -sys -audlog
Audit Log : off
Audit Log Category : -