HP Hitachi Dynamic Link Manager Software - Manual (Page 258)

6. Command Reference
236
-hba
HBA-adapter-number
.
bus-number
Or
-hba
adapter-type
.
adapter-number
Use this parameter to place offline, at one time, all the paths that pass through a
specific HBA port. The command will place offline all the paths connected to the
HBA port that has the specified HBA-adapter-number
.
bus-number or
adapter-type
.
adapter-number.
Specify the HBA adapter number and bus number, or adapter type and adapter
number, of the target HBA port: the numbers are found in the PathName field
displayed using the
view
operation. Enter a period between these two parameter
values. For details about the
view
operation, see 6.7 view (Displays
Information). The HBA-adapter-number
.
bus-number and
adapter-type
.
adapter-number strings are case-sensitive.
Example
The following example shows how to place offline all paths connected to the
HBA port whose HBA adapter number is
01
and bus number is
01
.
When the confirmation message is displayed, the user enters
y
to continue,
or
n
to cancel the operation.
# /usr/DynamicLinkManager/bin/dlnkmgr offline -hba 01.01
KAPL01055-I All the paths which pass the specified HBA
will be changed to the Offline(C) status. Is this OK? [y/
n]:y
KAPL01056-I If you are sure that there would be no problem
when all the paths which pass the specified HBA are placed
in the Offline(C) status, enter y. Otherwise, enter n.
[y/n]:y
KAPL01061-I 3 path(s) were successfully placed
Offline(C); 0 path(s) were not. Operation name = offline
#
-hbaid
HBA-port-ID
Use this parameter to place offline, at one time, all paths that pass through a
specific HBA port. The command will place offline all paths connected to the
HBA port that has the specified HBA-port-ID. To display the HBA port IDs,
execute the following
view
operation:
# /usr/DynamicLinkManager/bin/dlnkmgr view -hba
For details about how to execute the
view
operation to display the HBA port IDs,
see (4) To Display HBA Port Information in 6.7.2 Parameters.