HP ProLiant ML350e Gen8 Server - Manual (Page 60)

Hardware options installation 60
7. Remove the system air baffle (on page 30 ).
8. Open the DIMM slot latches..
9. Install the DIMM.
SAS drive options
When adding drives to the server, observe the following general guidelines:
• The system automatically sets all device numbers.
• If only one drive is used, install it in the bay with the lowest device number (" SAS and SATA device
numbers " on page 15 ).
• Drives must be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
Installing a hot-plug drive option
The server supports SAS, SATA, or solid state drives.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server or the
enclosure unless all drive and device bays are populated with either a component or a blank.
To install the component:
1. Do one of the following:
o For tower models, open and remove the bezel (" Remove the tower bezel " on page 22 ).
o For rack models, if installed, remove the security bezel (on page 24 ).