HP ProLiant ML350e Gen8 Server - Manual (Page 61)

Hardware options installation 61
2. Remove the drive blank.
3. Prepare the drive.
4. Install the drive.
5. Determine the status of the drive from the drive LED definitions (on page 19 ).
Installing a non-hot-plug drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To install the component:
1. Do one of the following:
o For tower models, open and remove the bezel (" Remove the tower bezel " on page 22 ).
o For rack models, if installed, remove the security bezel (on page 24 ).