HP ProLiant ML350e Gen8 Server - Manual (Page 73)

Hardware options installation 73
Installing the FBWC module (P222, P420, P421, and P822)
CAUTION: The cache module connector does not use the industry-standard DDR3 mini-DIMM
pinout. Do not use the controller with cache modules designed for other controller models,
because the controller can malfunction and you can lose data. Also, do not transfer this cache
module to an unsupported controller model, because you can lose data.
To install the component:
1. Do one of the following:
o For tower models, open and remove the bezel (" Remove the tower bezel " on page 22 ).
o For rack models, if installed, remove the security bezel (on page 24 ).
2. Power down the server (on page 22 ).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 27 ).
5. Remove the access panel (on page 25 ).
6. Remove the PCI air baffle (on page 28 ), if installed.
7. Install the FBWC module into the storage controller.
8. Install the storage controller, if not already installed.
9. Install the capacitor pack: