HP ProLiant DL385 G6 Server - Manual (Page 48)

Hardware options installation 48
3. Remove the hard drive.
Expansion board options
The server supports PCI, PCI-X, and PCI Express expansion boards.
Removing expansion slot covers
CAUTION: To prevent damage to the server or expansion boards, power down the server and
remove all AC power cords before removing or installing the PCI riser cage.
CAUTION: For proper cooling do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
1. Power down the server (on page 20 ).
2. Extend the server from the rack (on page 20 ).
3. Remove the access panel (on page 21 ).
4. Remove the PCI riser cage (on page 22 ).
5. Remove the expansion slot cover:
o To remove slot cover 1 or 4, push in on the retainer to release it, and then slide out the cover.