GE JVE40DTBB - Manual (Page 10)

10
49-80622-4
REMOVE FILTERS
Remove the protective shipping film from the edges
of the metal grease filters . Press the filter locks back and
lift the filters out . Set them aside .
REMOVE WIRING COVER
FROM THE JUNCTION BOX
Remove the wiring cover from inside the hood .
Set the cover and its mounting screw aside .
Wiring
cover
Mounting
Screw
REMOVE WIRING KNOCKOUT
Remove either the top or the back wiring knockout as
needed and install an approved strain relief clamp .
Strain relief
clamp
2
3
4
5
Filters
Installation Instructions
REMOVE DUCT KNOCKOUT(S)
If recirculating, non-vented ductless see note below and
skip to Step 7 and proceed.
Using a flat blade screwdriver, remove the appropriate
duct knockout(s) from the top or back of the hood .
3 1 ⁄
4
” x 10” Rectangular
vertical discharge.
Remove top rectangular
duct knockout only .
3 1 ⁄
4
” x 10” Rectangular
horizontal discharge . Remove
rear rectangular duct
knockout only .
NOTE: If the hood is to be installed in a recirculating,
non-vented ductless manner, order charcoal filters, kit
number WB02X11000 for 30 ” hood models . These kits
can be ordered from your GE supplier . Skip to Step 7C and
proceed.
NOTE: If the hood in installed for recirculation mode, it is
not E
nergy
S
tar ® certified .