GE JVE40DTBB - Manual (Page 8)

8
49-80622-4
PART QUANTITY
Metal Grease Filters 2
Mounting Screws 4
Exhaust Adaptor/Damper 1
(for 3 1 ⁄
4
” x 10” rect . venting)
Exhaust Adaptor Screws 1
• If the unit is damaged in shipment, return the unit to the
store in which it was bought for repair or replacement .
• If the unit is damaged by the customer, repair or
replacement is the responsibility of the customer .
• If the unit is damaged by the installer (if other than
the customer), repair or replacement must be made
by arrangement between customer and installer .
DAMAGE-SHIPMENT/INSTALLATION
PARTS INCLUDED
MOUNTING SPACE
NOTES:
• This range hood is for installation over ranges up to 30”
wide .
• If you are going to vent your range hood to the outside,
see the “Ducting Requirements” section for exhaust duct
preparation .
66” or
more from
the floor to
the top of
the hood
30” 30”
min .
Bottom edge of
cabinet needs
to be 30” or
more from
the cooking
surface
Flat blade and Phillips
screwdrivers
Pencil
Metal snips
(in some
applications)
Electric drill Saw (saber or
keyhole)
Duct tape
Pliers
Level Caulking
Tape measure
Charcoal Filters If recirculating
order Kit no . WB02X11000
OPTIONAL ACCESSORIES
This kits can be ordered from your GE supplier .
TOOLS YOU WILL NEED
1/4” pivoting
hex socket
Flashlight
Wire stripper
1/4” Nutdriver
Installation Instructions
Note: If the hood in installed for recirculation
mode, it is not E
nergy
S
tar ® certified .