GE JVE40DTBB - Manual (Page 13)

49-80622-4
13
TROUBLESHOOTING CHECKLIST
If the hood seems to be operating at high speed when
the control is not set on high, or if ventilation seems
inadequate, check the following:

Knockouts not removed from hood .
 Damper blade not opening .
 Reduced airflow because the duct is too small or the
duct length is too long .
 The duct is blocked .
 Undersized or restrictive wall or roof cap .
REPLACE WIRING COVER
Replace the wiring cover .
CONNECT WIRING
Connect house black to hood black wire, house white
to hood white wire, and house ground to hood green/
yellow wire . Securely tighten the strain relief clamp
onto the house wiring .
19
20
17
CONNECT DUCTWORK TO HOOD
Use duct tape to make joints secure and air tight .
Note: Illustration shows rectangular to round duct adapter .
Duct tape
16
REPLACE FILTERS
The installation is complete . Turn on power at service
panel, and test for proper operation .
Installation Instructions
21
WARNING:
Hg
- Lamp contains Mercury. Manage in accord with
disposal laws. See www.lamprecycle.org or 1-800-435-4448 .
For installation, handling and disposal precautions, refer to
the fluorescent lamp packaging literature .
WARNING:
n To reduce the risk of electric shock, do not connect electrical
power to the hood without both lamps in place.
CAUTION:
n Do not touch the hood lamps when they are on. They may
be hot enough to cause injury.
n To prevent injury from broken lamps, handle lamps carefully
and do not operate hood without lamp lens covers in place.
This hood requires two Compact Fluorescent Lamps (CFL)
with a GU24 base (included), maximum 15 watts .
To change the lamps:
When installing or replacing a lamp, make sure that
power to the light has been turned off . Never allow a
lamp to come into contact with water .
Remove the lens cover by sliding it in a horizontal direction
and pulling it down and away from the hood .
Grasp the lamp by the plastic base portion of the lamp
and unscrew it .
Replace with energy saving GE 15W Compact Fluorescent
Lamp with GU24 base GE Service Part: WB08X10064.
INSTALL LAMPS
FOLLOW ELECTRICAL CODE
Complete the electrical wiring according to National
Electrical Code and local codes .
NOTE: This hood must be permanently grounded .
Connect house wiring (120 VAC) to hood wiring .
18