GE JAS02SNSS - Manual (Page 16)

Special features of your oven control.
Tones at the End of a Timed Cycle
Cook and Hold
12 Hour, 24 Hour or Clock Black-Out
Changing the Speed of the + or - Pads
At the end of a timed cycle, 3 short beeps will sound
followed by one beep every 6 seconds until the
Clear/Off pad is touched. This continuous 6 second
beep may be canceled.
To cancel the 6 second beep:
Touch the Bake and Broil Hi/Lo pads at the
same time for 3 seconds until the display
shows SF.
Touch the Broil Hi/Lo pad. The display
shows Con Beep (continuous beep). Touch
the Broil Hi/Lo pad again. The display
shows Beep. (This cancels the one beep
every 6 seconds.)
Touch the Start pad.
You new control has a cook and hold feature that
keeps cooked foods warm for up to 3 hours after
Timed Baking or Roasting is finished.
NOTE: This feature can only be programed to work
with Timed Baking or Roasting. (See the Using
the timed baking and roasting features section.)
After Timed Baking or Roasting has automatically
stopped, the programmed Cook and Hold will
automatically start.
To activate this feature for use after Timed
Baking or Roasting, follow the steps below:
Touch the Bake and Broil Hi/Lo pads at the
same time for 3 seconds until the display
shows SF.
Touch the Cooking Time pad. The display
will show Hld Off.
Touch the Cooking Time pad again to
activate the feature. The display will read
Hld On.
Touch the Start pad to activate the cook
and hold feature and leave the control set
in this special features mode.
Your control is set to use a 12 hour clock.
If you would prefer to have a 24 hour military
time clock or black-out the clock display, follow
the steps below.
Touch the Bake and Broil Hi/Lo pads at the
same time for 3 seconds until the display
shows SF.
Touch the Timer/Clock pad once. The
display will show 12 hr. If this is the choice
you want,touch the Start pad.
Touch the Timer/Clock pad again to change to
the 24 hour military time clock. The display will
show 24 hr. If this is the choice you want touch
the Start pad.
Touch the Timer/Clock pad again to black-out
the clock display. The display will show Off. If this
is the choice you want, touch the Start pad.
NOTE: If the clock is in the black-out mode you
will not be able to use the Delay Start function.
As you use the + or - pads when setting a time or
temperature, you may notice the display changes
slowly. This special feature allows you to change
the speed. To set the speed you prefer, follow the
steps below:
Touch the Bake and Broil Hi/Lo pads at the
same time for 3 seconds until the display
shows SF.
Touch the + pad. The display will show you
a set speed between 1 and 5.
Touch the + pad to increase the speed
down to the number 1.
Touch the - pad to decrease the speed
down to the number 1.
Touch Start to activate the setting and
leave the control set in this special features
mode..
16