GE JAS02SNSS - Manual (Page 39)

39
Problem Possible Causes What To Do
Oven temperature too
hot or too cold
Oven thermostat needs
adjustment.
• See the Adjust the oven thermostat - Easy to do yourself!
section.
Clock and timer do
not work
Plug on rang is not completely
inserted in the electrical outlet.
• Make sure electrical plug is plugged into a live, properly
grounded outlet.
A fuse in your home may be
blown or the circuit breaker
tripped.
• Replace fuse or reset circuit breaker.
Oven controls improperly set. • See the Using the clock, timer, and convenience outlet
section.
Display goes blank A fuse in your home may be
blown or the circuit breaker
tripped.
• Replace the fuse or reset the circuit breaker.
The clock is turned off from
showing in the display.
• See the Using the clock, timer, and convenience outlet
section.
Oven door is crooked The door is out of position. • Because the oven door is removable, it sometimes gets
out of position during installation. To straighten the door,
push down on the high corner.
Oven makes clicking
noise
This is the sound of the heating
element turning off and on during
the cooking functions.
• This is normal.
“F-and a number or
letter” flash in the
display
You have a function error code. • Press the OFF pad. Put the oven back into operation
If the function code repeats: • Disconnect all power to the range for at least 30 seconds
and then reconnect power. If the function error code
repeats, call for service
• On self-cleaning models, if a function error code appears
during the self-cleaning cycle, check the oven door latch.
• Press the OFF pad. Allow the oven to cool for one hour.
Put the oven back into operation.
Power outage Power outage or surge • Some models will automatically resume their setting
once the power is restored. On models with a clock, you
must reset the clock. If the oven was in use, you must
reset it by pressing the OFF pad, setting the clock and
resetting any cooking function.
Display flashes Power failure • Reset the clock.
Unable to get the
display to show “SF”
Oven control pads were not
pressed properly
• The BAKE and BROIL pads must be pressed at the same
time and held for 3 seconds.
“Burning” or “oily
odor emitting from
the oven vent
This is normal in a new oven and
will disappear in time.
• To speed the process, set a self-cleaning cycle for a
minimum of 3 hours. See the Using the self-cleaning oven
section.
Strong odor An odor from the insulation
around the inside of the oven is
normal for the first few times the
oven is used.
• This is temporary.
GEAppliances.com