GE PV977NSS - Manual (Page 4)

4
49-80550-2
MEMORY/OFF. To set the memory:
A. Press the MEMORY/OFF button.
B. Set your desired fan and light settings.
C. Press the MEMORY/OFF button again to save these
settings.
With your desired settings in memory, press the
MEMORY/OFF button to restore the fan and light
levels to their saved settings. These settings will
remain in memory until they are changed or loss of
power occurs.
To turn off the hood, press the MEMORY/OFF button.
LIGHT. Press + or – to increase or decrease light level
to desired setting. There are 2 light levels (LOW, HIGH)
and OFF. If you continue to press the + or – buttons,
the light will cycle back through the settings.
NOTE: Please check the lamps to ensure only 20W
lamps (maximum) are installed.
FAN. Press + or – to increase or decrease fan level
to your desired setting. There are 4 fan levels (LOW,
MED, HIGH, BOOST) and OFF. If you continue to press
the + or – buttons, the fan will cycle back through the
settings.
NOTE: There is an audible “beep” each time a button
is pressed. This is normal.
NOTE: The collars around the buttons will illuminate
when pressed. This is normal. The collars will
automatically turn off if the hood is turned off.
HEAT SENSOR:
This hood is equipped with a heat sensor that will turn
on the fan if excessive temperatures are detected (over
Û&Û) DERYHWKHFRRNLQJVXUIDFH7KHKRRGZLOO
return to its normal operation once the heat sensor detects
WHPSHUDWXUHVEHORZÛ&Û)
NOTE: If the hood is OFF or on LOW fan speed, the
WHPSHUDWXUHVDERYHÛ&Û)DUHGHWHFWHG WKHQWKHIDQ
will automatically adjust to MED speed. You may adjust
the fan speed to HIGH or BOOST, but you will not be able
to adjust the fan speed to LOW or OFF until temperatures
EHORZÛ&Û)DUHGHWHFWHG
NOTE: The collars around the buttons may not illuminate if
the heat sensor is activated. This is normal.
Using the hood controls.