GE ZET2SMSS - Manual (Page 35)

35
Care and Cleaning
Wall Oven
The door is very heavy. Be careful when removing
and lifting the door.
Do not lift the door by the handle.
To remove the door:
1 Fully open the door.
2 Pull the hinge locks down toward the door
frame, to the unlocked position. A tool, such as a
small flat-blade screwdriver, may be required.
3 Firmly grasp both sides of the door at the top.
4 Close door to the door removal position, which
is most of the way and lift it up and out until
the hinge arm is clear of the slot.
To replace the door:
1 Firmly grasp both sides of the door at the top.
2 With the door at the same angle as the
removal position, seat the indentation of the
hinge arm into the bottom edge of the hinge
slot. The notch in the hinge arm must be fully
seated into the bottom of the slot.
3 Fully open the door. If the door will not fully
open, the indentation is not seated correctly in the
bottom edge of the slot.
4 Push the hinge locks up against the front frame
of the oven cavity, to the locked position.
5 Close the oven door.
Lift-off
oven
GRRU³
removal
Hinge arm
Indentation
Bottom
edge
of slot
Removal position
Hinge lock
Slot
Pull hinge locks down to unlock
Hinge
lock
Hinge
arm
Push hinge locks up to lock
Probe
The temperature probe may be cleaned with
soap and water or a soap-filled scouring pad.
Cool the temperature probe before cleaning.
Scour stubborn spots with a soap-filled scouring
pad, rinse and dry.
Do not immerse the temperature probe in water.
Do not store the temperature probe in the oven.