GE ZET2SMSS - Manual (Page 36)

36
Care and Cleaning
Wall Oven
Oven lights Each oven is equipped with two halogen light
assemblies located on the side walls of the oven.
The lights come on when the door is opened or
when the oven is in a cooking cycle. The oven
lights do not come on during self-cleaning orif the
Sabbath Feature is set.
Each light assembly consists of a removable light
cover with two locking clips, a light compartment
with three light bulb sockets and three halogen light
bulbs.
CAUTION:
Before replacing the bulb,
disconnect electrical power to the oven at the main
fuse or circuit breaker panel.
Be sure to let the light cover and bulb cool
completely.
For your safety, do not touch a hot bulb with bare
hands or a damp cloth.
To remove:
Remove the racks from the oven. See the Full
extension oven racks section.
Using an adjustable wrench, remove the four
nuts holding the rack support over the light
assembly.
Remove the glass light cover by pulling its back
edge out and rolling it toward you.
Do not remove any screws.
NOTE: The two locking clips may fall from the
glass light cover. Upon replacement, they will
need to be placed in the correct position on
the light cover and pressed back into the light
compartment until seated.
Using gloves or a dry cloth, remove the burned-
out light bulb by pulling it straight out.
To replace:
Use a new 120-volt Halogen bulb, with G8 pins, not
to exceed 25 watts.
Replacement bulbs may be purchased by calling
800.626.2002. Order Part Number WB25T10064.
NOTE: Higher wattage bulbs will damage your
oven.
Using gloves or a dry cloth, remove the bulb from
its packaging. Do not touch the bulb with bare
fingers. Oil from bare fingers may cause hot spots
on the glass surface and lead to premature failure
of the bulb. If you do touch the glass, clean it with
alcohol prior to installation.
Push the bulb straight into the receptacle all the
way.
Replace the light cover, by placing its front edge
under the front two tabs in the light
compartment. Roll the back edge into place,
making sure that it is firmly seated.
NOTE: If the
locking clips
fell from the
glass lens cover,
hold them on
the cover, in the
correct position,
while replacing
the cover on the
light compartment.
The light cover must be in place when using the oven.
For improved lighting inside the oven, clean
the glass cover frequently using a wet cloth.
This should be done when the oven is off,
disconnected from the power supply, and
completely cool.
Replace the rack support with the slotted holes
over the rear bolts and the round holes over the
front bolts. Lightly secure with the four nuts
removed earlier, but do not over-tighten or the
enamel could be chipped.
Replace the racks. See the Full extension oven
racks section.
Reconnect electrical power to the oven.
Round
holes
over
front
bolts
Slotted
holes
over
rear
bolts
Hold
locking
clips in
place on
lens cover
back edge
Press the light cover
into place
Place
front
edge
of lens
cover
under
front two
tabs
(Top bracket shown)