Ag Leader PF3000/PF3000Pro Harvest Master Mode Operators Manual - Manual (Page 9)

PF3000 and PF3000 Pro Using PF with HarvestMaster
Ag Leader Technology Setup
September 2000 7
Travel Distance Per Pulse: Measure the diameter of the wheel that has
the ground speed sensor installed. Use the following formula to
determine the setting:
Travel Distance Per Pulse =
Tire Diameter (feet or meters) x 3.14
Number of magnets
Tank Type: If you are not using a sugar beet harvester ignore this setting.
If you are using a sugar beet harvester, refer to the HarvestMaster
instructions for the proper setting.
Discharge Delay: If you are not using a sugar beet harvester ignore this
setting. If you are using a sugar beet harvester, this setting is the time in
seconds from when the beets come out of the tank until they pass the
weighing rollers again, on their way to the truck. Typically this setting is
8 – 11 seconds.
Discharge Rate: If you are not using a sugar beet harvester ignore this
setting. If you are using a sugar beet harvester, this is the rate in lbs/sec
(or kgs/sec if metric) at which the beets come out of the holding tank.
Determine this setting by timing how much material comes out. Typical
settings are 50 –100 lbs/sec (23 – 45 kgs/sec).