Ag Leader GPS 4100 Operators Manual - Manual (Page 15)

GPS 4100 General Instructions
Ag Leader Technology
March 2001 13
If you will
be using
RACAL… Then…
Before contacting RACAL you must have the Receiver
Serial Number (Found on the Add-On GPS Diagnostic
screen – Press DIAG key, GPS key, Add-On GPS key) and
the Provider User Code (this value will appear on screen
shown on Figure 6 when Differential Provider is set to
RACAL). Call the RACAL subscription number (1-888-
434-7757 in the USA) and give them these two numbers.
RACAL will activate a code for the serial number that was
given. After the serial number is called in, press the EXIT
key (Figure 12) to return to operating screen. A "D"
should appear in the upper right hand corner of the
PF3000. Within 15 to 30 minutes the receiver should start
receiving corrections from RACAL.
SATELLITE DIFFERENTIAL SETUP
Differential Source
Satellite
Differential Provider RACAL
Satellite Frequency 1553.345000
Satellite Baud Rate 1200
Provider User Code 8111
OMNISTAR Code 000000000000000000000000
ACCEPT EXIT
Figure 12.