Ag Leader GeoSteer RTK 900 MHz Installation Manual - Manual (Page 2)

2 GS-900 Radio Kit Installation Instructions
LEGAL DISCLAIMER
The manufacturer disclaims any liability for damage or injury that results from failure to follow the instructions and
warnings set forth herein.
Note: The installation procedures must be performed by an authorized, fully trained and certified dealer technician.
Note: Read and follow ALL instructions in this guide carefully before installing any hardware or operating the steering system.
Note: Take careful note of the information in the Safety Information section and throughout this guide.
Special Requirements
Tools
This list consists of the tools required to complete the installation. The installer is assumed to have a complete set of common
installation tools.
15/16” open wrench #3 Phillips screwdriver Cleaning rags
10mm open wrench Ladder, 10 ft (3 m) Wire cutter small
Flat screwdriver
Technical Support
Refer to your Display user manual for technical support information.
Contact Information
Refer to your Display user manual for contact information.
Copyright © 2012 All Rights Reserved