ididit Retrofit Steering Column: 1967-72 Ford Truck - Manual (Page 5)

3
Wiring
The ididit column has an OEM type
turn signal switch. That being said
there was a difference between the
plug configurations on the 67-69 vs.
the 70-72.
The early group had two connectors,
one with 6 wires and one with 2
wires. The later had the same 8
wires, but all in one connector.
Late Early
The terminals are the same eight wires in both configurations. If your
wiring is still intact, you could use your original plug. You would plug one
wire at a time (matching the original colors on both sides) into the original
terminal. Unfortunately, most of the original plugs we were working with
were cracked or damaged. Ididit has provided an extra set of connectors
and terminals with this column. You will have to plug each wire terminal
into these plugs before installation. Remember that these wires have to
match thte color on the adjoining side.
1967-68 Ford Truck Cross Over Chart
Vehicle Harness Function ididit Column Harness
Blue Turn Flasher Feed Blue
White/Blue Right Front Turn/Indicator White/Blue
Green/White Left Front Turn/Indicator Green/White
Green Right Rear Turn/Brake Orange/Blue
Yellow Left Rear Turn/Brake Green/Orange
Red/Black Brake Feed Green
Blue/Yellow Horn Ground Blue/Yellow
1969-72 Ford Truck Cross Over Chart
Vehicle Harness Function ididit Column Harness
Blue Turn Flasher Feed Blue
White/Blue Right Front Turn/Indicator White/Blue
Green/White Left Front Turn/Indicator Green/White
Green Right Rear Turn/Brake Orange/Blue
Yellow/Black Left Rear Turn/Brake Green/Orange
Red/Black Brake Feed Green
Blue/Yellow Horn Ground Blue/Yellow