Innovate Motorsports MTX-D, EGT Gauge - Manual (Page 8)

- 8 -
4.2 Logging data
1. Power OFF the MTX EGT gauge
2. Connect the supplied serial cable to the port labeled OUT.
3. There should be nothing connected to the port labeled IN.
4. Power ON the MTX EGT gauge.
5. Connect the serial cable to your computer. If you are using a serial to USB adapter,
connect the serial cable to the adapter then connect the adapter to the computer.
6. Launch LogWorks. The LogWorks application can be launched from Start->Programs-
>LogWorks3->Logworks3 from the Windows task bar.
7. Once LogWorks launches go to File->Connect. You will be prompted to connect to serial
COM port. Click Connect.
8. To start recording go to File->New Real-time Log or, in the Toolbar, click on the Tool.
5 Changing the MTX-L’s gauge face and/or bezel
1. Lay the MTX-L face down and remove the three #2 phillips screws from the outside rim of
the back plate.
2. Carefully lift out the bezel from the gauge cup.
3. Configure the gauge as desired by changing the gauge face and or bezel.
*Be sure to remove protective film from the gauge face. This can be done easily
with a piece of scotch tape.
4. Make sure every piece is positioned correctly using the locating tab and reassemble the
gauge.
5. Reinstall the 3 #2 phillips screws.