Innovate Motorsports MTX-D, Water Temperature/Volt Gauge User Manual
Page 5
- 5 -
3.2
Hooking up the MTX Water Temp/ Volt gauge to the computer
1. Power OFF the MTX Water Temp/ Volt gauge
2. Connect the supplied serial cable to the port labeled OUT.
3. There should be nothing connected to the port labeled IN.
4. Power ON the MTX Water Temp/ Volt gauge.
5. Connect the serial cable to your computer. If you are using a serial to USB adapter,
connect the serial cable to the adapter then connect the adapter to the computer.
6. Launch LM Programmer. The LM Programmer application can be launched from Start-
>Programs->LogWorks3->LM Programmer from the Windows task bar.
3.3
Programming the Gauge
Whenever a change is made to the programming of the gauge click the Program button for the
change to take effect. Once the gauge has been programmed the Program button will grey out.
To set the gauge back to the factory settings click the Set To Defaults button and then click the
Program button.
3.4
Temp Tab
1. The
Display In will allow the gauge to display the temperature in either Imperial or Metric
unit of measure.
2. The Water Temperature Alarm will enable the gauge’s seven segment to flash when the
entered threshold value has been exceeded. To enable this feature the “Enable” option
must be checked.