Innovate Motorsports MTX-D, Boost/Shift Gauge - Manual (Page 10)

- 10 -
5 Changing the MTX gauge face and/or bezel
1. Lay the MTX gauge face down and remove the three #2 phillips screws from the outside
rim of the back plate.
2. Carefully lift off the bezel from the gauge cup.
3. Configure the gauge as desired by changing the gauge face and or bezel.
*Be sure to remove protective film from the gauge face. This can be done easily
with a piece of scotch tape.
4. Make sure every piece is positioned correctly using the locating tab and reassemble the
gauge.
5. Reinstall the 3 #2 phillips screws.