Nitrous Express Pushrod Style 5.0L Plate - Manual (Page 4)

Note: The nitrous and fuel solenoids are rated only for intermittent duty. Do not engage either solenoid for more than 20
continuous seconds. Solenoids that have “burned or scorched” electro-magnets will not be replaced under warranty.
WIRING DIAGRAM
TESTING AND USING THE SYSTEM
All NX systems are designed for off road usage. Use extreme caution and observe all safety precautions (see your vehicles owner’s
manual). Select a suitable test area; your local racetrack is best. Arm the system with the cockpit N2O arming switch. Gently launch the vehicle,
gradually accelerating to wide-open throttle. When WOT is achieved a noticeable surge of power should be produced. If not stop and recheck all
installation procedures. Call the factory tech line if the problem cannot be located. NOTE: All vehicles equipped with factory rev-limiters should
take extreme care not to over-rev the engine. If the rev-limiter is engaged with the N2O system on, serious engine damage could result. An
aftermarket RPM window switch (NX PN# 18959) should be used to disengage the N2O system 200 RPM’s before the rev-limiter activates.
Your NX system is now ready for regular usage.
SAFETY TIPS
Do not attempt to start engine if nitrous has been accidentally injected while the engine was not running. Disconnect coil wire(s) and turn
motor with throttle wide open for several revolutions before attempting to restart. If it is not possible to disable the ignition then the spark plugs
must be removed and the engine cleared of all nitrous before attempting to start engine.
1. Never permit oil, grease, or any other readily combustible substances to come into contact with nitrous cylinders, valves, solenoids, hoses and
fittings. Oil and certain gases (such as oxygen or nitrous oxide) may combine to produce a flammable condition.
2. Never interchange solenoids or other appliances used for one compressed gas with those used for another.
3. Identify the gas content by the label on the bottle before using. If the bottle is not identified to show the gas contained, return the bottle to the
supplier.
4. Do not deface or remove any markings, which are used for content identification.
5. Cylinder valves should be closed except when nitrous is actually being used.
6. Notify supplier of any condition, which might have permitted any foreign matter to enter the valve or bottle.
7. Never drop or violently strike the bottle
8. Keep valves closed on all empty bottles to prevent accidental contamination. Open the bottle valve for an instant to clear opening of any
possible dust or dirt before usage. Aim bottle outlet away from all body parts. Do not point it in the direction of a person.