Nitrous Express EFI NITROUS PLATE SYSTEM FOR GT500 - Manual (Page 3)

3
MOUNTING THE NITROUS PLATE:
Before any modifications are made under the hood, we suggest that you make a diagram of all hoses
wiring and linkages.
1. Pre-assemble the nitrous plate before you begin. Select the horsepower setting that you want to start
with, insert the proper nitrous jet in the fitting marked “N2O” (CAUTION: You must always use a
back-up wrench when tightening the nitrous or fuel fittings, failure to do so will void the system
warranty!!!!!) Connect the blue stainless feed line to the plate fitting. The nitrous fitting can be
identified by the “N2O” marked on the plate. Repeat this procedure for the red fuel line (the fuel fitting
will be marked “FUEL”). NOTE: Always check each jet for obstructions before installing.
2. Remove the throttle body.
3. Using the supplied O-ring, re-install the throttle body in front of the nitrous plate and torque to factory
specs using the provided hardware.
4. Install plate as shown below in ILLUSTRATION C
ILLUSTRATION C