Nitrous Express CARBURETOR PLATE SYSTEMS - Manual (Page 4)

4
ILLUSTRATION B
HITMAN WIRING
WIRING THE SOLENOIDS
1. Mount the master arming switch within easy reach, and plain sight of the driver.
2. The system is furnished with a universal wide-open throttle switch. This WOT micro-switch is designed to
work with the universal mounting bracket. It’s maximum capacity is 10 AMPS and should only be used to
activate low amp draw accessories or in conjunction with a relay.
3. Assemble the micro-switch on the mounting bracket using the supplied bolts and nuts. The switch can be
mounted in several different configurations, select the position your application requires and tighten the bolts.
Do not over- tighten; the plastic micro switch can be damaged.
4. The mounting bracket is made of easily bendable material and may be formed to any configuration that will
allow it to place the WOT switch in the proper location.
5. The activation arm on the micro-switch is extra-long. This allows you to twist, bend, or cut it to aid in the
ease of installation. Attach an 18-ga. jumper wire from the remaining terminal “ACC” of the master arming
switch to one of the terminals on the wide open throttle switch.
6. The best power source for the nitrous system is the terminal on the back of the alternator labeled “BAT”.
The next best power source is directly to the “Positive” post on the battery. Do not try to “Splice” into the
factory wiring harness for a power supply, this will not have adequate amperage to operate the solenoids. If
desired a 40 amp fuse may be installed in this circuit.