Nitrous Express Bottle Mounting - Manual

Mounting the Bottle
The bottle should be mounted in the trunk area or outside of the passenger
compartment. If this is not possible or practical a NHRA approved blow down tube
and vent fitting (PN 11708 and 11709) must be installed. The best positioning of
the bottle is shown in diagram “A”.
DIAGRAM A
Mounting the bottle in this manner will allow the internal siphon tube to be covered
with liquid nitrous at all times and properly supports the bottle. Refer to the chart
below to determine the suggested bracket spacing.
Assemble the brackets on the bottle with the short bracket on the bottom
(motorcycle brackets are the same height) and the top bracket the specified distance
apart as shown on the chart below. This assembly will serve as a template to locate
the four mounting holes. The bottle brackets should be secured by grade 5 bolts
and washers. Before drilling the holes be sure to check for clearance beneath the
mounting surface, i.e.: fuel tank, fuel lines, and brake lines. Each dimension given
below is from the bottom of the bottle to the center of the bracket, a 10% variance
in spacing, if necessary, is acceptable.