1time-based curve, Time-based curve – Nitrous Express Boost Reference Progressive User Manual
Page 6
4
Solenoid Frequency is the rate at which the controller cycles the solenoids. This number is
determined by the solenoid manufacturer. [14 will work with all solenoids but may not be the optimum
frequency]
3
3
.
.
4
4
.
.
1
1
T
T
i
i
m
m
e
e
-
-
B
B
a
a
s
s
e
e
d
d
C
C
u
u
r
r
v
v
e
e
Present allows you to permanently turn off a stage. A check mark tells the controller to activate the
stage as per the configuration. No check mark means this stage is always OFF.
Enable First-Gear Lockout disables the stage until the RPM has exceeded the RPM Cutoff at least
once since it was armed.
Input #2 will determines what effect this input will have
on the applicable stage. Enable allows the stage to
function normally while Disable turns the stage off. If you
are not using this input set it to be ignored by.
RPM Cutoff allows you to set the upper RPM threshold
above which the nitrous will be turned off.
MAP Cutoff allows you to set the upper boost threshold
above which the nitrous will be turned off.
RPM Trigger allows you to set the minimum RPM
required before the Nitrous can be triggered.
Delay sets the time that the controller will delay starting
the ramp once a stage has been activated
RAMP TIME sets the build time for the ramp
Start sets the start percentage of the stage.
Final sets the final percentage of the stage. The ramp will maintain this level until the RPM cut-off is
reached or the stage is deactivated by the TPS or RPM window.
NX - rev A