PowerTap Cervo 2.4 Pro - Manual (Page 26)

PR
4
4
SLEE
PR
4
mi
PR
4
pedal
c
Hu
P
POWERTAP Only
PR
4
mi
watts
POWERTAP Only
26
COMPUTER SETUP 4
This setup menu includes: sleep time, locations of display, cadence source, cycle com-
puter mode, heart rate monitor, and auto start/stop. You are unable to move back to a
previously viewed settings. You must restart setup 4 to make corrections.
1) Press [SELECT] to set how many minutes the computer will stay
“awake” after not receiving a valid speed or heart rate signal. Press
[MODE] to save. NOTE: The shorter the sleep time the better the
battery life.
2) Press [SELECT] to determine what is displayed in the middle line.
(mi = speed, c = cadence, (
) = heart rate). Press [MODE] to save.
The selected metric will flash during the ride.
3) Press [SELECT] to determine cadence information source.
Default = pedal then hub
Pedal = crank only
Hub = hub only
Press [MODE] to save.
This setting only applies when a PowerTap hub is installed.
4) The Cervo2.4 can be used as a cycle computer or heart rate
monitor. Press [SELECT] to toggle through mode options.
watts, mi, and ( ) = power meter mode
mi, and ( ) = cycle computer mode
( ) = heart rate monitor mode
Press [MODE] to save.
This setting only applies when a PowerTap hub is installed.