Yetter 2984 Series Generation II Maverick Opener - Manual (Page 11)

11
ASSEMBLY INSTRUCTIONS
STEP 7. When the optional residue manager 2984-003 will be used, the 2984-312 stop plate should be
assembled to the unit at this time. The 2) 21/32” x 1 ¼” x ¼” flat washers are to be set aside for later use in
the residue manager assembly. Do not fully tighten 5/8 castle nut, do not install 1/8” x 1” cotter pin at this
time.
STEP 8. Attach the 2984-306 (RH KNIFE ARM) and 2984-307 (LH KNIFE ARM) to the hub plate using 4)
5/8” x 1 ¾” hex bolts and 5/8” lock nuts. Use the lower set of mounting holes in the hub plate.