Yetter 2984 Series Generation II Maverick Opener - Manual (Page 25)

25
ASSEMBLY INSTRUCTIONS
2984-008 – V-CLOSE WHEEL ASSEMBLY
STEP 5. Attach the 2502-346 – ½” x 2” full thread bolt to the 2984-324 mount plate through the lower rear
hole. This bolt is used as a down stop for the v-close wheel assembly. adjust the bolt side to side so the
bolt will stop the down travel of the v-close wheel assembly.
STEP 6. Attach the 2984-325 spring anchor (attached to the spring) to the knife mount replacing the
bottom bolt of the knife using 1) ½” x 2 ½” GR 8 ZYD bolt and reuse the ½” lock nut.