Yetter 2984 Series Generation II Maverick Opener - Manual (Page 8)

8
ASSEMBLY INSTRUCTIONS
2984-002 – MAVERICK OPENER GEN II
STEP 1. Mark the location of the center of each row on the toolbar. Then measure from row 4” and place a
mark on the rear side of toolbar. This mark will give a reference point to where the edge of the clamp
bracket (3000-368) should be located so that the fertilizer knife will be centered directly on the row.
STEP 2. Centering on each row, attach the (3000-122) parallel arm assembly to the toolbar with the
appropriate ¾” u-bolts, lock washers and hex nuts. Torque the u-bolts to 200 ft. lbs. Recheck the torque
after 10 hours of use.