GReddy TURBO KITS: Toyota Celica GTS 2000-02 / MP62 User Manual
Page 10
(3) Cut off the OE injector harness connectors and
replace with Kit injector harness connectors.
※
※
※
※
※
Mark or label harness wires to ensure that they are
connected to the proper pin on the injector.
Do not connect the injector connector at this time.
Double check connections
④ Wrap with electrical tape
③ Solder wires
② Wrap wires together
① Remove sleeve
Solder procedure
3-10 OE Engine Wire Harness
C
D,E
B
A
(1) Split the OE Wire harness in this way: A – alternator
B+ wire, B – alternator connector, C – A/C
compressor, D – knock sensor, E – crank position
sensor. Wrap the wires with the provided colgate
tubing.
Combine the knock sensor and crank position sensor
wire harness into the same colgate tube.
Cut the colgate tube to the proper lengths and tape
then ends of the tubing with electrical tape.
〈Part №19〉
B,C,D,E
A
(2) Connect the sensor harness connectors and
alternator connectors and use cable ties to secure
wires. Connect engine harness to injector
connectors.
Route the alternator B+ wire in front of the
supercharger and connect to alternator.
〈Parts №17,18〉
―10―