GReddy TURBO KITS: Toyota Celica GTS 2000-02 / MP62 - Manual (Page 17)

３－16 Starting the Engine
(1) Install the radiator reserve tank to its original location and fill with coolant.
Bleed the air from the cooling system after starting engine.
(2) Install the battery tray and batter. Connect the B+ terminal of the battery.
(3) Inspect all harness connectors and wire connections and connect the B – terminal of the batter.
(4) Start the engine and inspect fuel lines and injectors for any fuel leaks.
※
※
Check the e-manage unit to see if the active light is green. If it is not, please check the e-manage
wire connections to the OE ECM.
Check to see if the e-manage unit has error codes (active light blinks red).
(5) At idling, inspect for water or vacuum leaks.
(6) Install the RH engine under cover.
(7) Install the upper front fender apron seal and cylinder head cover No.2.
This completes the Supercharger Kit installation
IMPORTANT
o It is very important that you monitor the boost pressure, and make sure not to over boost.
Over boosting can cause engine damage.
o GReddy Performance Products, Inc. is not responsible for any engine damage caused by over
boosting (increased boost), modification to the kit, and/or misuse of the product. NO
WARRANTY is offered.
o Due to lack of control over proper installation and use of this product,
NO WARRANTY is offered for this kit.
―１７―