GReddy TURBO KITS: Toyota Celica GTS 2000-02 / MP62 - Manual (Page 13)

Harness Grommet Ground
A B ３－13 Kit e-manage Ultimate installation
(1) Remove the ECM box cover and disconnect and
remove connector A, B, and ground from the box.
Remove the electrical tape to all the harness
grommet to move freely. The ECM is on the right side
of the engine bay.
(2) Locate the A/C line going through the right side of
the firewall. Cut the grommet in the center to allow
the wire harness to pass through the firewall.
(3) Route the wire harness through the firewall.
〈Part №２３〉
e-manage harness
(4) Route the e-manage harness through the ECM
harness grommet from the smaller end of the
grommet.
(5) Refer to the wire diagram to connect e-manage wires
to the ECM wire harness.
Wrap with heat shrink tube and electrical tape
Wrap wires and
solder together
Remove cover
After connections are completed, place all of the
wire connectors back in the ECM box and place the
harness grommet back to its original location.
※ Place the connectors A and B in the ECM box before
connectors C and D.
The kit does include connectors for electrical wiring, but it is highly recommended to solder
all wire connections to ensure proper function. Also please confirm that all wires are
wrapped with electrical tape.
―１３―