Outback Power Systems MATE2 System Controller and Display Installation and User Manual - Manual (Page 14)

14
Fourth screen (one of the following):
• The MATE found an FX Series
Inverter/Charger
• The MATE has found a Charge Controller.
• The MATE has found the HUB.
The MATE has found the FLEXnet DC.
• Port Assignment screen follows the HUB Found
screen
• Each Port used will show its connected
component.
• The MATE has not found an OutBack product.
If the MATE does not find the connected device,
refer to page 129, Troubleshooting
Searching for Devices
FX Found
Searching for Devices
CC Found
Searching for Devices
HUB Found
Port Assignment
1> FX 2> FX 3> CC 4> CC
5> 6> 7> 8>
9> 10> 2M>
Searching for Devices
No Devices Found
Searching for Devices
DC Found