Outback Power Systems MATE2 System Controller and Display Installation and User Manual User Manual
Page 73
73
ADV/MATE/GRIDUSE----------------
weekend 12:00A
griduse start time
DOWN UP CHANGE
ADV/MATE/GRIDUSE----------------
weekend 12:00A
griduse stop time
DOWN UP CHANGE
Weekend Grid-Use Start
This setting is the time during the weekend (Sat-
urday and Sunday) that a <USE> will be issued to
an FX system, allowing the FX to connect to the
AC input source. The time displayed is the default
setting. To change the time press the <CHANGE>
soft key and adjust the time as you would for a
weekday setting. Press the <DOWN> soft key to
view the weekend griduse stop screen.
This setting is the time during the weekend (Sat-
urday and Sunday) that a DROP will be issued
to the FX system, forcing the FXs to disconnect
from the AC input source. The time displayed is
the default setting. To change the time press the
<CHANGE> soft key and adjust the time as you
would for a weekday setting.
After setting the START and STOP times, scroll
back to the first GRID-USE enable screen using
the <UP> soft key. Press the <ON> soft key to
activate GRID-USE Mode.
Weekend Grid-Use Stop