Outback Power Systems MATE2 System Controller and Display Installation and User Manual - Manual (Page 87)

87
ADV/MATE/AGS-----------------------
choose category
QUIET VOLT
SETUP TIME START PG2
ADV/MATE/AGS/PG2----------------
choose category
LOAD MUST
PG1 START RUN PG3
ADV/MATE/AGS/LS------------------
load start 0 kw
DOWN AGS INC DEC
ADV/MATE/AGS/LS------------------
load start 1 min
delay
DOWN UP INC DEC
Go to the ADV/MATE/AGS screen and press the
<P2> soft key.
At the ADV/MATE/AGS/PG2 screen, press the
<LOAD START> soft key.
In the load start kw screen, an AGS start command
will be issued when the total AC load of all the FXs
connected to the MATE exceeds this setting for the
load start delay (next screen) time. A zero value
disables any load start function. <INC> and <DEC>
adjusts this setting between 1 – 50kW. After the
value has been set, press the <DOWN> soft key to
get to the load start delay screen.
This setting is the delay time that the total system AC
load must remain above the load start kw setting (see
previous screen), before the generator is started. It is
adjustable from 1 to 240 minutes using the <INC>
and <DEC> soft keys. After making any adjustments
to the delay time, press the <DOWN> soft key to go
to the load stop kw screen.
Load Start KW
Load Start Delay
To open the Load Start screen: