Outback Power Systems MATE3 Owners Manual - Manual (Page 160)

Specifications
158 900-0117-01-00 Rev C
Table 10 Installer Settings (Battery Monitor Settings)
Menu
Menu
Option
Menu Items Set Points
Installer
Settings
Page
Battery Amp-hours
Charge Voltage
Time
Minutes
Charged Return Amps
Battery Setup
Charge Factor _____%
112
Shunt A (Enable/Disable)
Shunt B (Enable/Disable) Shunt Enable
Shunt C (Enable/Disable)
112
FLEXnet Relay Mode
Status (ON or OFF)
Invert Logic (?)
113
Voltage: High ___Vdc
Voltage: Low ___ Vdc
SOC: High ___%
SOC: Low ___%
Delay: High _______
FLEXnet Relay Set
Points
Low: _______Minutes
113
System
Battery
Monitor
Reset to Factory
Defaults
Y or N 114
Table 11 Installer Settings (MATE3 Settings)
Menu
Menu
Option
Menu Items Set Points
Installer
Settings
Page
AGS Enabled
Port
Fault Time
Warmup Time
Cool Down Time
DC Gen Set
Setup
Voltage Stop
116
24 Hour Start Enable
2 Hour Start Enable Voltage Start
2 Minute Start Enable
118
Enabled
Start Load Start
Stop
118
Enabled
Start SOC ___%
Stop SOC ___%
State-of-
Charge Start
Enable Full Change (Y/N)
118
Enable
Weekday Start
Weekday Stop
Weekend Start
System MATE3 AGS
Must Run
Schedule
Weekend Stop
119