Outback Power Systems MATE3 Owners Manual - Manual (Page 77)

System Settings
900-0117-01-00 Rev C 75
Saving a Configuration to an SD Card
Figure 75 Saving the Configuration to an SD Card
To save a configuration to an SD card:
1. From the Main Menu, select Settings.
2. From the Settings Menu, select System.
3. From the System Configuration menu, select
Save/Restore Information.
4. Select the Save System Configuration menu item.
5. If other profiles have been saved on the SD card, a list will
be displayed. Choose one of the following options.
 Press <Save> to save the new settings over the name
that is selected on the list.
OR
 Press <New> to create a new name for the profile.
See the instructions below for entering a new name.
OR
6. After performing one of the two options above,
press
<Continue> to return to the Main Menu.
To save the new profile over the name highlighted on the list:
1. Use the control wheel to scroll through the list.
2. When the name to be replaced is highlighted, press <Save>.
3. Wait for the message confirming that the profile has been saved
to the SD card.
4. Press <Continue> to return to the Main Menu.
To create a new name for the profile (up to 8 characters
maximum):
1. Use the control wheel to scroll through the available characters.
2. Use <> or <> to move to the desired character location.
3. Press <Delete> to erase the character that is highlighted.
4. Press <Save> to save the new profile on the SD card.
5. Press <Continue> to return to the Main Menu.
NOTE: If the SD card is empty, pressing the <Save> soft
key will automatically default to the New Wizard
Configuration File menu to allow a name to be
entered (up to 8 characters maximum).
Returns to the Main Menu.
Returns to the Main Menu.