Vaisala DMT346 - Manual (Page 90)

User's Guide _______________________________________________________________________
90 ___________________________________________________________________ M210762EN-G
List of Serial Commands
All commands can be issued either in uppercase or lowercase. In the
command examples, the keyboard input by the user is in bold type.
The notation <cr> refers to pressing the carriage return (Enter) key on
your computer keyboard. Enter a <cr> to clear the command buffer
before starting to enter commands.
In the tables below, the bold text in the brackets is the default setting.
Table 18 Measurement Commands
Command Description
R Start the continuous outputting
S Stop the continuous outputting
INTV [0 ... 255 S/MIN/H] Set the continuous output interval
(for RUN mode)
SEND [0 ... 255] Output the reading once
DSEND Output the reading once from all connected
transmitters (in STOP or POLL mode)
SMODE
[STOP/RUN/POLL/MODBUS] Set the serial interface mode
SERI [baud p d s] User Port settings (Default: 4800 E 7 1)
ADDR [0 ... 255] Set the transmitter address (for POLL and
MODBUS modes)
NET View or set networking parameters for LAN
and WLAN interfaces
WLAN View or set wireless network parameters
for WLAN interface
OPEN [0 ... 255] Open temporarily connection to a POLL
mode device
CLOSE Close the temporary connection (back to
POLL Mode)
Table 19 Formatting Commands
Command Description
FORM Set the output format of SEND and R
commands
FST Add the state of AutoCal, purge and sensor
warming in connection with SEND and R
commands
SCOM Assign a new command name that works
like the SEND command
FDATE Add date to R and SEND outputs
FTIME Add time to output to SEND and R outputs