Vaisala DMT346 - Manual (Page 91)

Chapter 4 _________________________________________________________________ Operation
VAISALA ________________________________________________________________________ 91
Table 20 Data Recording Commands
Command Description
DIR Lists trend log files
PLAY [0 ... 24] [START END] Output recorded data file. Start and end
times can only be specified if the data
logger module is installed. The times must
be given in the following format:
yyyy-mm-dd hh:mm:ss
DSEL Select logged (and displayed) quantities
(1 ... 4)
DELETE Delete all data files, including the memory
of the optional data logger module
UNDELETE Recover the deleted files that have not
been overwritten
Table 21 Purge Commands
Command Description
PUR Purge settings
PURGE Start manual purge
Table 22 Autocalibration Commands
Command Description
AUTO AutoCal settings
AUTOCAL Start manual AutoCal
Table 23 Calibration and Adjustment Commands
Command Description
FCRH RH two-point adjustment
AØ1 Td/f one-point adjustment
CT T one or two-point-adjustment
ACAL Perform analog output adjustment
Table 24 Setting and Testing the Analog Outputs
Command Description
ASEL Configure analog output quantities and
scales
ITEST Test analog outputs
AMODE Display analog output mode
AERR Change the error output
ASCL Analog output scaling
AOVER [ON/OFF] Extend analog output range by 10%
Table 25 Setting and Testing the Relays
Command Description
RSEL Configure relay settings
RTEST Test relays