Vaisala PTB330 - Manual (Page 76)

USER'S GUIDE____________________________________________________________________
74 __________________________________________________________________ M210855EN-D
UNIT [x] [y]
where:
x = Output quantity
y = Output unit
Use the UNIT command to change the measurement unit for the
quantities. The output consists of all the measured quantities of the
unit you enter as variable [y].
Example:
>unit Pa
P : Pa
P3h : Pa
P1 : Pa
P2 : Pa
DP12 : Pa
HCP : Pa
QFE : Pa
QNH : Pa
>
Use the UNIT command with a quantity symbol to change the
measurement unit for a specific quantity. Specify the quantity and the
desired unit for it.
Example:
>unit P mmhg
P : mmHg
P3h : Pa
P1 : Pa
P2 : Pa
DP12 : Pa
HCP : Pa
QFE : Pa
QNH : Pa
>
NOTE This command changes both the serial output and display units.
Use the UNIT ?? command to list the available measurement units for
the quantities.