Vaisala GMP343 - Manual (Page 34)

User’s Guide ______________________________________________________________________
32 ___________________________________________________________________M210514EN-E
Setting the Continuous Outputting
Interval
INTV xxxx yyy <cr>
SAVE <cr>
xxxx=output interval (1...1000) default=1 s
yyy=unit (s, min or h)
Example: Output interval is changed to 5 seconds
>intv 5 s
INTERVAL : 5
UNIT : S
>
Outputting the Reading Once
In STOP mode:
SEND <cr>
In POLL mode:
SEND aa <cr>
aa=address of the transmitter when more than one transmitter is connected
to a serial bus (0...99).
The output mode can be changed with the command FORM.
>send
348.7 ppm
>
Setting the Serial Interface Measurement
Mode
SMODE xxxx <cr>
SAVE <cr>
xxxx= STOP/RUN/POLL