Vaisala GMP231 - Manual (Page 30)

User's Guide _______________________________________________________________________
28 ___________________________________________________________________ M211501EN-C
Serial Commands
All commands can be issued either in uppercase or lowercase. In the
command examples, the keyboard input by the user is in bold type.
The notation <cr> refers to pressing the carriage return (Enter) key on
your computer keyboard. Enter a <cr> to clear the command buffer
before starting to enter commands.
Table 7 Basic Serial Commands
Command Description
? Show probe information.
CLOSE Close connection to probe (POLL mode)
ECHO Show or set remote echo mode.
ENV Show or set environmental parameters.
ERRS Show currently active errors.
FORM [modifier string] Show or set output format.
HELP Show list of currently available serial
commands.
INTV [0 ... 9999 s/min/h] Set continuous output interval for R command.
OPEN [address] Open connection to probe in POLL mode
PASS [1300] Access advanced serial commands.
R Start the continuous outputting.
RESET Reset the probe.
S Stop the continuous outputting.
SDELAY [0 ... 255] Show or set serial line transmission delay in
milliseconds.
SEND Output measurement message once.
SERI [baud data stop parity] Show or set the serial interface settings
SMODE [mode] Show or set startup serial mode:
RUN, STOP, or POLL.
SNUM Show probe serial number.
STANDBY [on/off] Standby mode on/off (turn off measurement)
SYSTEM Show probe firmware information
TIME Show probe operation hours and uptime
VERS Show probe firmware version.