Acer 6000 - Manual (Page 63)

AcerPower 6000 User’s Guide 3-16
The Base Address and IRQ parameters are
configurable only if the Parallel Port is enabled.
If you install an add-on card that has a parallel port
whose address conflicts with the parallel port on
board, a warning message appears on the screen.
Check the parallel port address on the add-on card
and change the address to one that does not conflict.
Operation Mode
This item allows you to set the operation mode of the parallel port. Table 3-1 lists
the different operation modes.
Table 3-1 Parallel Port Operation Mode Settings
Setting Function
Standard Parallel Port (SPP) Allows normal speed one-way operation
Standard and Bidirectional Allows normal speed operation in a two-
way mode
Enhanced Parallel Port (EPP) Allows bidirectional parallel port operation
at maximum speed
Extended Capabilities Port
(ECP) Allows parallel port to operate in
bidirectional mode and at a speed higher
than the maximum data transfer rate
ECP DMA Channel
This item becomes active only if you select Extended Capabilities Port (ECP)
as the operation mode. It allows you to assign DMA channel 1 or DMA channel 3
for the ECP parallel port function (as required in Windows 95).