VariZoom VZCINEMAPRO-JR-K2 - Manual (Page 10)

- 10 -
Speed adjustment
Basic speed adjustment for pan and tilt can be made in the main menu screen. Move the
cursor box to “spd” using the setup knob, and press “enter”. The setup knob will then
change the speed for both pan and tilt (the number shown in the box is a percentage of the
advanced speed setting). Pressing the “enter” button again will allow you to change the
advanced speed setting. In this menu the setup knob will adjust tilt speed, and the focus
knob will adjust pan speed. The number shown in the box is a percentage of full speed
capability. Press enter again to keep your selection, and return to the main screen.
4. Motion Response
From the main screen press the “menu” button, Select the “response” menu.
Here you can adjust parameters for Pan, Tilt, zoom, and focus. Select the axis that
you’d like to adjust.
Smoothing will adjust how “quick” the axis will respond. Smoothing can be adjusted
from 1-100. 1 being instant response, and 100 being the maximum delay in response.
Smoothing will also affect the how quick the axis will slow down while making the
move.
Speed will adjust the advanced speed setting. The numbers in the box are the same
numbers that appear in the advanced speed setting accessible from the main screen.
Deadband only affects the joystick. It will adjust the amount the joystick must be moved
before the axis responds. Deadband can be adjusted from 1-100. 1 being minimum
amount of movement before response, and 100 being maximum amount of movement
before response.
Direction- In will change the direction in which the signal is sent to the head. It is what
you will need to change to reverse axis responds. I.E. if tilt is set + turning the encoded
wheel clockwise will tilt the camera up, and pressing the joystick forward will tilt the