VariZoom VZCINEMAPRO-JR-K2 - Manual (Page 5)

- 5 -
The “cancel” button is used to cancel the last item changed, or to back out of a sub menu.
Pressing “cancel” twice will always return to the main screen.
The “Q” button is basically a shift key, and is used to change the function of other
buttons.
The “Record” “rev” “stop” and “play” are used for the motion control features. This will
be addressed later on.
The main menu screen will show pan, tilt, zoom, and focus positions. It will also display
which take is enabled, which go to mark is enabled, as well as a few basic functionality
adjustments.
When changing the value of a parameter, the setup knob will increase or decrease the
value in increments of 1. Hold the “Q” button while moving the setup knob, and the
values will move in increments of 10. Hold the “menu” button while moving the setup
knob, and values will move in increments of 100. Hold both the “Q” and “menu” buttons
while moving the setup knob, and the values will change in increments of 1,000.
Display Contrast can be adjusted from the second setup menu.
While in the main screen, press the “menu” button twice.
Select the “contrast” option.
Contrast can be adjusted from 0-100
2. Basic Setup
-Secure the head to crane, tripod, or solid mounting beam
-Plug the FACTORY POWER SUPPLY into AC mains
-Connect XLR cable between head and FACTORY
POWER SUPPLY
-Plug green control cable into the head and the jack
marked “CTRL” on the Advanced Controller (or Jibstick,
if applicable)
-If applicable, connect camera power (red) and lens
control cables (orange) and route the cables through the
tilt axis port hole to connect to your camera
-Make sure to turn camera power on as the LAST step.