VariZoom VZCINEMAPRO-JR-K2 - Manual (Page 17)

- 17 -
Select “Jog Time” from the setup menu
Under the “jog time” option, you can set the number of seconds the Head will take to go
from mark to mark, from zero to mark, or from mark to zero.
Under “jog motion” you can choose either “s-curve” or “linear”. This is how the speed
will vary throughout the motion.
“s-curve” will start slow, speed up, then slow down before all axes reach their
destination.
“Linear” will start slow, and then increase speed. Maximum speed will be reached at no
more than 50% of the move.
“linear ramp” will adjust the percentage of the move the Head will take to reach full
speed in while “linear” is selected.
13. Camera
This is related to the camera run (aka record start/stop) feature available through the lens
control interface. If you are connecting to your lens from the CP JR’s orange-coded jack,
you may be able to start and stop recording by pressing the “Q” (shift) button along with
the “<” (enter) button. The ‘camera’ menu allows you to change the settings for the
start/stop feature. If start/stop is already working properly, you don’t need to change
anything in this menu. If the feature isn’t working, you can try changing the settings of
“Camera Trigger”. If the “C” prompt is showing up out of sync with the camera record
state, you can change the “Run Feedback” setting. “Select camera” is just a preset and
should remain on “Custom” unless you’re using a Red One.
14. PT-Z
PT-Z is the menu where you can change the Pan/Tilt sensitivity according to the position
of the zoom axis.