VariZoom VZCINEMAPRO-JR-K2 - Manual (Page 15)

- 15 -
From here, you can select the take where you want to store your move.
The bottom left will display how long the existing take is (if it is empty it will display
“0”), and how many seconds are available for recording in the system’s memory.
Press the “record” button. If a move is already stored it will read “overwrite take?”
Press enter to overwrite. It will then read “hit record to start”
Once you hit record, it will instantly begin recording the moves for all applicable axes
(pan, tilt, zoom, focus, and iris)
When you are done, press the “stop” button
Note: You can record a “go to mark” maneuver.
Before you begin recording, make sure that the desired mark is already displayed in the
upper left.
Begin recording.
Any time during the recording hold the “Q” button and press “play”. The Head will then
automatically move from the current position to the mark point displayed in the upper
left. This can be done as many times as necessary during the recording.
Playing back a move- Select the take that you wish to play back
Press the “play” button. All recorded axes will then move to the starting point of the
selected take.
After the all axes have returned to the start point, press “play” again, and the Head will
play back the recorded move.
Note: During playback of a move, the joystick, panbars, or handwheels, will be disabled
until the axes are done playing back the move.
Manual control on axes during playback- It is possible to isolate a specific axis or axes
to be disabled from playing back while the other axes play back the move.
From the main screen select the “enl” option.
Then select which axis you’d like to disable from playback
On the lower left, next to “playback” it will display either “active” or “live”
When “active” is displayed, the axis will be played back during a move.
When “Live” is selected, the axis will be disabled from playback, but you will be able to
control that axis with the controller while the other axes playback the move.