VariZoom VZCINEMAPRO-JR-K2 - Manual (Page 14)

- 14 -
Once you choose where you want to store the mark, press “enter”
Move the axes to the position that you wish them to set for this mark position.
Select the “set” option.
From the sub menu select “Mark”
This will then record all current axes positions to the mark displayed in the upper left.
Recalling Marks
To recall a mark position, select the “Mark” number you wish to recall from the main
screen. (The axis positions will be displayed in the lower right)
Select the “Go To” option
From the sub menu, select “Mark”
All axes will go to the position that is recorded for this mark.
Note: A quick way to scroll through marks. While holding the “Q” key, press “Play” and
the mark numbers will increase. Press “Stop” and the mark numbers will decrease. This
is much faster than scrolling with the setup knob.
Jog Time is the speed and time that the Head will take to move to and from a mark, or to
and from zero. This can be adjusted for linear ramping, and will be addressed in more
detail in a later chapter.
9. Recording moves
The Head can record up 4,650 seconds of motion. Basic remote software only allows one
take to be stored. An optional upgrade to your software allows up to 2000 takes to be
stored. Takes can be played back in real time, or stretched in time-lapse with the optional
intervalometer (The intervalometer will be addressed in more detail in a later chapter)
Recording a move- Select the take where you want to store the move. From the main
screen, move the cursor box to the number next to the “take” option.