VariZoom VZCINEMAPRO-JR-K2 - Manual (Page 18)

- 18 -
PT-Z can be adjusted between 0-100. The greater the number the slower the pan and tilt
axes will respond according to the position of the zoom axis. When 0 is selected, zoom
will not affect the pan and tilt axes.
Note: This is only accurate when using the Varizoom TOC system, Preston MDR2,
Canon lens with digital servos, or Fujinon lens with digital servos. If you are using a
Canon or Fujinon lens with Analog Servos, the zoom positions will not be accurate, and
with feature will not function properly.
15. Servo Tuning
Servo tuning should not be changed from the factory settings. If the settings have been
changed from the factory settings or you suspect they may have changed, you can check
them by entering the second setup menu (hit “Menu” twice, then select “Tuning”)
These settings are factory preset, and should never be changed. If they
have been changed, they must be changed back to the following, or the
Pan and Tilt motors will perform poorly and possibly be damaged.
CinemaPro JR Servo Tuning
KP: 80 KI: 15
KD: 250 IL: 25
After the setting is made, move the cursor box to the “ok” option, and press “enter”. The
settings will not be saved until this is done. Settings should be the same for both pan and
tilt axes.